Profitec MOVE - Inserting the Silicone Attachment and Filters in the Portafilter

MOVE_BA_V1.0EN - 100
4. Turn the tamper slightly to achieve an even surface.
9 The ground coffee is now pressed and compacted.
9.6 Inserting the silicone attachment and lters in the
portalter
The scope of delivery for the machine includes 1x silicone attachment, 1x
one-cup lter, 1x two-cup lter, 1x three-cup lter, and 1x blind lter with the
following functions:
• Silicone attachment with two spouts for the controlled dispensing of
espresso
• Cup lters for preparing espresso and cappuccino
• Blind lter for cleaning the brew group
Fig.6 Portalter with two-cup lter and silicone attachment
The silicone attachment is installed by default, but can be removed for
cleaning (see Chapter 11.1, “Cleaning the portalter, silicone attachment, and
lters”). Install the silicone attachment as follows:
1. Hold the portalter with the P logo (4, Fig.6) facing up.
2. Use both hands to press the silicone attachment (2, Fig.6) into the
portalter from below until it has fully latched in place.
Insert the lters as follows:
1. With one hand, hold the portalter with the P logo (4, Fig.6) facing up.
2. Use the other hand to insert the relevant lter (1, Fig.6) into the
portalter.
3. Press the lter in using both thumbs until it latches into place.
3
4
2
1