To Next Page

To Previous Page

Page 227

P145 Tel. No.1

This parameter is used to enter the number of ‘0’s that appear at the

beginning of the telephone number to be dialled that is to receive the

message.

Option

Description

0= None

No ‘0’s present at the beginning of the

telephone number to be dialled.

1 = Add 0 (Default)

1 ‘0’ present at the beginning of the

telephone number to be dialled.

2= Add 00

2 ‘0’s present at the beginning of the

telephone number to be dialled.

P146 Tel. No2

This parameter is used to enter to enter the next 6 digits, following the ‘0’s,

of the telephone number to be dialled. If there are less than 8 digits

following the ‘0’s then just enter the digits required, if there are more than 8

digits following the ‘0’s then enter the first 6 digits and then proceed to

P147 and enter the remaining digits.

P147 Tel. No3

This parameter is used to enter any remaining digits of the telephone number

to be dialled after completion of P145 and P146 above.

Example

Telephone number to be dialled is: 0 1234 123456

P145 Tel. No. 1 = 1(One ‘0’ at the beginning of the telephone number)

P146 Tel. No. 2 = 123412 (The next 6 digits following the ‘0’s).

P147 Tel. No. 3 = 3456 (Remaining digits of telephone number).

P148 Timed Out

This parameter will set the time period that the unit will wait for a reply

before disconnecting. Default = 90 seconds

P149 Retry No.

This parameter will set the number of times the telephone number will be re-

dialled if no reply is received. If set to ‘0’ then the number will be re-dialled

continually until a reply is received, if set to ‘-1’ then number will not be re-

dialled at all. Any other value entered between 1 and 99 will determine the

number of re-dials to be attempted. Default = 0

Pulsar ULTRA 5 User Manual

Other manuals for Pulsar ULTRA 5