2.4.2 Removal or modification of safety equipment
Depending on the model, the machine is fitted with different safety
equipment for protection against serious personal injury.
Removing, modifying or decommissioning safety equipment is pro‐
hibited.
If safety equipment has been modified, damaged, removed or is not
fully functional, the machine must be shut down and secured immedi‐
ately. Defects must be rectified immediately.
All protective devices must be undamaged, completely fitted and fully
functional. This must be checked through daily visual checks.
If moving protective devices are fitted, an additional function check
must be carried out every time before using the machine.
2.4.3 Conveyed material
The machine is only designated for conveying media specified in the
machine's technical data. Its performance is limited to operation on
construction sites or in workshops. The maximum delivery pressure
must not exceed that specified on the rating plate or in the technical
data.
2.4.4 Extending the delivery line
Extension of the delivery line beyond the length specified in the tech‐
nical data is forbidden.
A new delivery line is only suitable for pressures entered on the rating
plate.
2.4.5 Pressurised systems
Opening pressurised systems (delivery line) is prohibited. Before
opening, the pressure must be dumped or the entire system must be
depressurised.
2.4.6 Site of use
The machine is not approved for operation in potentially explosive
areas (unless stated otherwise).
Safety regulations
2 — 6
To Next Page
