WARNING
Risk of crushing due to turning of the auger pump
Depending on the mounting position of the stator or screw conveyor
barrel, it can turn all the way to the stop when the machine is
switched on.
▶
Secure the machine against unauthorised or accidental starting.
▶
Never reach into the auger pump while switching the machine
on.
▶
For screw conveyor barrels with a stop, this must be secured at
the stop of the mixing pipe.
5. Insert the mixer shaft back into the mixing pipe and secure it in
the screw conveyor opening.
6. Close the mixer motor again.
Align the mixer shaft retainer on the mixer motor and the mixer
shaft.
CAUTION
Danger of crushing when the mixer motor is closed
▶
Close the mixer motor carefully. Do not let it fall.
7. Close the turnbuckle to secure the mixer motor.
5.2 Checks
Each time your machine is used, you should check the condition of
the machine and carry out a test run including function checks. If you
identify any defects during the checks, you must eliminate these (or
have these eliminated) immediately.
Starting up
5 — 6
To Next Page
