2. Press the foot brake down fully in order to prevent the machine
rolling inadvertently.
NOTICE
Risk of machine damage due to inclination angle that is too large
The full functionality of the machine is no longer ensured for larger
inclination angles. These conditions will lead to increased wear or
machine damage.
▶
The maximum permitted inclination angle can be found in the
“Technical data” section of the “General technical description”
chapter.
▶
The machine must not be operated beyond the specified incli‐
nation angles.
3. Align the machine horizontally. Observe the permitted inclination
angles.
Release the foot brake again before moving the machine.
4.7 Mounting the injection hood
To mount the injection hood, proceed as follows:
WARNING
Risk of injury due to the machine starting unexpectedly
▶
Secure the machine against unauthorised starting.
▶
The machine must not be started up without a fully functional
protective device.
1. Remove the grille from the reservoir.
Transport, setting up and connection
4 — 16
To Next Page
