● The local laws and regulations must be observed.
● Protection in the case of indirect contact must be ensured through
the automatic cut-out of the supply in line with IEC
60364-4-41:2005.
DANGER
Risk of death due to fatal electric shock
▶
Work on the electrical system may only be carried out by certi‐
fied, licensed and qualified electricians (proof of qualification in
line with EN 60204, part 1, page 14, item 2.21).
DANGER
Risk of death due to incorrect electrical connection or damaged
electrical lines
▶
Before establishing electrical connections, check that the elec‐
trical lines are not damaged.
▶
Make sure that the electrical connections have been establish‐
ed correctly.
4.9.1 Power sources
Electrical installation prerequisites should be checked by a qualified
electrician before connection work begins.
The machine must be connected to a separate feed point on con‐
struction sites. The following power sources are permissible as a spe‐
cial feed point:
● Site power distribution point
● Small site power distribution point
● Protective distributor
● Movable protective device
Transport, setting up and connection
4 — 19
To Next Page
