2.4.10 Changing the works settings
The works settings must not be changed. A few examples are listed
below:
● Pressure and performance settings
● Software versions and software parameters
2.4.11 Structural changes
Structural changes must not be implemented without permission from
the manufacturer. A few examples are listed below:
● Accessories and attachments not explicitly approved by the manu‐
facturer must not be fitted.
● Alterations or modifications that could compromise safety must not
be carried out.
● Welding work on load-bearing parts, pressure containers, fuel or
oil systems is not permitted.
● Welding work is only permitted following consultation with the man‐
ufacturer and with express permission.
● Welding work may only be carried out by authorised qualified per‐
sonnel.
2.4.12 Wrong bolts/nuts and tightening torques
Only nuts and bolts corresponding to the specifications in the spare
parts sheets may be used.
Nuts and bolts may only be tightened with the specified tightening tor‐
ques.
The following nuts and bolts must not be reused:
● Self-locking nuts
● Bolts with adhesive in the locking threads
● Bolts of property class 10.9 and higher
2.5 Liability
The operator is obliged to act in accordance with the Operating In‐
structions.
Safety regulations
2 — 8
To Next Page
Loading...
