8 – Connection Security Configuration
Managing SSL and SSH Services
8-2 59183-02 A
S
Enter the Set Setup Services command to manage both SSH and SSL services
as shown in the following example:
SANbox #> admin start
SANbox (admin) #> set setup services
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
PLEASE NOTE:
-----------
* Further configuration may be required after enabling a service.
* If services are disabled, the connection to the switch may be lost.
* When enabling SSL, please verify that the date/time settings
on this switch and the workstation from where the SSL connection
will be started match, and then a new certificate may need to be
created to ensure a secure connection to this switch.
TelnetEnabled (True / False) [True ]
SSHEnabled (True / False) [False] True
GUIMgmtEnabled (True / False) [True ]
SSLEnabled (True / False) [False] True
EmbeddedGUIEnabled (True / False) [True ]
SNMPEnabled (True / False) [True ]
NTPEnabled (True / False) [False]
CIMEnabled (True / False) [False]
FTPEnabled (True / False) [True ]
MgmtServerEnabled (True / False) [True ]
Do you want to save and activate this services setup? (y/n): [n] y
To Next Page
Loading...
Need help?
General
