14 – Command Reference
Show Mem
59183-02 A 14-135
A
Show Mem
Displays information about memory activity.
Authority None
Syntax show mem [count]
Keywords [count]
The number of seconds for which to display memory information. If you omit
[count], the value 1 is used. Displayed memory values are in 1K block units.
Examples The following is an example of the Show Mem command:
SANbox #> show mem
procs memory swap io system cpu
r b w swpd free buff cache si so bi bo in cs us sy id
0 0 0 0 144924 884 60104 0 0 0 0 119 73 1 2 97
Filesystem space in use: 36156/40155 KB (90%)
NOTE:
This keyword will display memory activity updates until [count] is reached–it
cannot be interrupted. Therefore, avoid using large values for [count].
To Next Page
Loading...
