6 – Port Configuration
Testing a Port
6-14 59183-02 A
S
6.6.3
Display Port Test Results
You can display the test status while the test is in progress by entering the
Test Status Port command as shown in the following example:
SANbox (admin) #> test status port 1
Port Test Test Loop Test
Num Port Type Status Count Failures
---- -------- ---- ------ ----- --------
1 1 Offline Internal Passed 12 0
6.6.4
Cancel a Port Test
To cancel a port test that is in progress, enter the Test Cancel Port command.
To Next Page
Loading...
