Qlogic SANbox 5000 Series - Zoning Configuration Defaults; SNMP Configuration Defaults

14 – Command Reference
Reset
59183-02 A 14-59
A
Enter the Show Config Zoning command to display zoning configuration
values.
Enter the Show Setup SNMP command to display SNMP configuration
values.
Table 14-10. Zoning Configuration Defaults
Parameter Default
MergeAutoSave True
DefaultZone Allow
DiscardInactive False
Table 14-11. SNMP Configuration Defaults
Parameter Default
SNMPEnabled True
Contact <syscontact undefined>
Location <sysLocation undefined>
Description SANbox 5000 Series FC Switch
Trap [1-5] Address Trap 1: 10.0.0.254; Traps 2–5: 0.0.0.0
Trap [1-5] Port 162
Trap [1-5] Severity Warning
Trap [1-5] Version 2
Trap [1-5] Enabled False
ObjectID 1.3.6.1.4.1.1663.1.1.1.1.17 (SANbox 5200)
1.3.6.1.4.1.1663.1.1.1.1.30 (SANbox 5202)
1.3.6.1.4.1.1663.1.1.1.1.23 (SANbox 5600
1.3.6.1.4.1.1663.1.1.1.1.24 (SANbox 5602)
AuthFailureTrap False
ProxyEnabled True