59183-02 A 13-1
Section 13
Simple Network Management Protocol Configuration
This section describes the following tasks:
Managing the SNMP Service
Displaying SNMP Information
Modifying the SNMP Configuration
Resetting the SNMP Configuration
The Simple Network Management Protocol (SNMP) provides for the management
of the switch through third-party applications that use SNMP. Security consists of
a read community string and a write community string that serve as passwords
that control read and write access to the switch. These strings are set at the
factory to well-known defaults and should be changed if SNMP is to be enabled.
13.1
Managing the SNMP Service
You control the SNMP service SNMPEnabled parameters through the
Set Setup SNMP or Set Setup Services commands. Refer to “Modifying the
SNMP Configuration” on page 13-4 for more information.
To Next Page
Loading...
