1 – Introduction
Switch Models and Examples
1-2 59183-02 A
S
1.1
Switch Models and Examples
The commands and displays of the command line interface vary depending on the
switch model. All examples in this guide are taken from a SANbox 5600 switch
unless stated otherwise.
1.2
Intended Audience
This guide is intended for individuals who are responsible for installing and
servicing Fibre Channel equipment using the command line interface.
1.3
Related Materials
The following manuals and materials are referenced in the text and/or provide
additional information.
îš„ SANbox 5000 Series Fibre Channel Switch Installation Guide, 59096-05
îš„ SANbox 5000 Series QuickTools Switch Management User Guide,
59235-02
îš„ SANbox 5000 Series Enterprise Fabric Suite 2007 User Guide, 59097-05
îš„ QLogic Fibre Channel Switch Event Message Guide, publication number
59060-04
îš„ SANbox Simple Network Management Protocol Reference Guide,
publication number, 59047-08
îš„ CIM Agent Reference Guide, 59223-01
îš„ QLogic Switch Interoperability Guide v3.0. This PDF document can be
downloaded at http://www.qlogic.com/interopguide/info.asp#inter.
îš„ Fibre Channel-Arbitrated Loop (FC-AL-2) Rev. 7.0.
îš„ Fibre Channel-10-bit Interface Rev. 2.3.
îš„ Definitions of Managed Objects for the Fabric Element in Fibre Channel
Standard (draft-ietf-ipfc-fabric-element-mib-04.txt).
The Fibre Channel Standards are available from:
Global Engineering Documents, 15 Inverness Way East, Englewood, CO
80112-5776 Phone: (800) 854-7179 or (303) 397-7956
Fax: (303) 397-2740.
To Next Page
Loading...
Need help?
General
