14 – Command Reference
Zoning Edit
59183-02 A 14-185
A
Zoning Edit
Opens a Zoning Edit session for the non-volatile zoning database or the merged
zone set in which to create and manage zone sets and zones. Refer to the “Zone”
command on page 14-174 and the “Zoneset” command on page 14-177.
Authority Admin session
Syntax zoning edit [database]
Keywords [database]
Opens an edit session for the zoning database given by [database]. If you omit
[database], a edit session for the non-volatile zoning database is opened.
[database] can have the following values:
configured
Opens a zoning edit session for the non-volatile zoning database.
merged
Opens a zoning edit session for the temporary merged zone set received
from another switch.
Examples The following is an example of the Zoning Edit command:
SANbox #> admin start
SANbox (admin) #> zoning edit
SANbox (admin-zoning) #>
.
.
SANbox (admin-zoning) #> zoning save
The changes have been saved; however, they must be activated
before they can take effect -- see zoneset activate command.
To Next Page
Loading...
Need help?
General
