Qlogic SANbox 5000 Series - Configuring a RADIUS Server on the Switch

10 – RADIUS Server Configuration
Configuring a RADIUS Server on the Switch
59183-02 A 10-3
A
10.2
Configuring a RADIUS Server on the Switch
Enter the Set Setup Radius command to configure a RADIUS server on the switch
as shown in the following example. Refer to Table 14-23 for a description of the
RADIUS server configuration parameters.
SANbox (admin) #> set setup radius
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the attributes
for the server being processed, press 'q' or 'Q' and the ENTER key to do so.
If you wish to terminate the configuration process completely, press 'qq' or
'QQ' and the ENTER key to so do.
DeviceAuthOrder (1=Local, 2=Radius, 3=RadiusLocal) [Local]
UserAuthOrder (1=Local, 2=Radius, 3=RadiusLocal) [Local]
TotalServers (decimal value, 0-5) [1 ]
Server: 1
ServerIPAddress (dot-notated IP Address) [10.20.11.8]
ServerUDPPort (decimal value) [1812 ]
DeviceAuthServer (True / False) [True ]
UserAuthServer (True / False) [True ]
AccountingServer (True / False) [False ]
Timeout (decimal value, 10-30 secs) [10 ]
Retries (decimal value, 1-3, 0=None) [0 ]
SignPackets (True / False) [False ]
Secret (1-63 characters, recommend 22+) [**********]
Do you want to save and activate this radius setup? (y/n): [n]