11 – Event Log Configuration
Managing the Event Log Configuration
59183-02 A 11-3
A
11.2.1
Filtering the Event Log Display
You can customize what events are displayed according to the component or
severity level. Enter the Show Log Display command to filter the events in the
display. You can choose from the following severity levels and component events:
îš„ Informative events
îš„ Warning events
îš„ Critical events
îš„ E_Port events
îš„ Management server events
îš„ Name server events
îš„ Port events
îš„ Switch management events
îš„ Simple Network Management Protocol (SNMP) events
îš„ Zoning events
The following example filters the event log display for critical events.
SANbox #> show log display critical
11.2.2
Controlling Messages in the Output Stream
Enter the Set Log Display command to specify the severity level filter to use to
determine what messages are automatically displayed on the screen when they
occur. Alarms are always included in the output stream. The following example
includes warning and critical level messages in the output stream:
SANbox (admin) #> set log display warn
11.3
Managing the Event Log Configuration
Managing the Event Log Configuration consists of the following tasks:
îš„ Configure the Event Log
îš„ Display the Event Log Configuration
îš„ Restore the Event Log Configuration
To Next Page
Loading...
Need help?
General
