2 – Command Line Interface Usage
Downloading and Uploading Files
2-8 59183-02 A
S
2.7
Downloading and Uploading Files
There are several files that reside on the switch that you can download to the
workstation for examination or for safekeeping. These files include the following:
Backup configuration file (configdata)
Log files (logfile)
Support files (dump_support.tgz)
You can upload firmware image files or backup configuration files to the switch to
reinstall firmware or restore a corrupted configuration. The switch uses FTP to
exchange files between the switch and the workstation.
Refer to “Installing Firmware” on page 5-20 for information about installing
firmware.
Refer to “Back Up and Restore a Switch Configuration” on page 5-14 for
information about backing up and restoring a switch configuration.
Refer to “Creating and Downloading a Log File” on page 11-6 for information
about creating a log file.
Refer to “Creating a Support File” on page 2-5 for information about creating
a support file.
To download a file from the switch to the workstation, do the following:
1. Enter the FTP command and the switch IP address or symbolic name.
>ftp 10.0.0.1
2. When prompted for a user and password, enter the FTP account name and
password (images, images).
user: images
password: images
3. Set binary mode and use the Get command to download the file
(configdata).
ftp>bin
ftp>get configdata
xxxxx bytes sent in xx secs.
ftp>quit
To Next Page
Loading...
Need help?
General
