Qlogic SANbox 5000 Series - Set Setup Radius

14 – Command Reference
Set Setup Radius
59183-02 A 14-99
A
Examples The following is an example of the Set Setup RADIUS command:
SANbox (admin) #> set setup radius
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the attributes
for the server being processed, press 'q' or 'Q' and the ENTER key to do so.
If you wish to terminate the configuration process completely, press 'qq' or
'QQ' and the ENTER key to so do.
DeviceAuthOrder (1=Local, 2=Radius, 3=RadiusLocal) [Local]
UserAuthOrder (1=Local, 2=Radius, 3=RadiusLocal) [Local]
TotalServers (decimal value, 0-5) [1 ]
Server: 1
ServerIPAddress (dot-notated IP Address) [10.20.11.8]
ServerUDPPort (decimal value) [1812 ]
DeviceAuthServer (True / False) [True ]
UserAuthServer (True / False) [True ]
AccountingServer (True / False) [False ]
Timeout (decimal value, 10-30 secs) [10 ]
Retries (decimal value, 1-3, 0=None) [0 ]
SignPackets (True / False) [False ]
Secret (1-63 characters, recommend 22+) [**********]
Do you want to save and activate this radius setup? (y/n): [n]