2 – Command Line Interface Usage
Logging In to the Switch
2-2 59183-02 A
S
2.1
Logging In to the Switch
To log in to a switch through Telnet, open a command line window on the
workstation and enter the Telnet command followed by the switch IP address:
# telnet ip_address
The Telnet window opens prompting you for a login. Enter an account name and
password. The default account name is admin, and its password is password.
switch login:admin
password: xxxxxxxx
Warning: Your user account password has not been changed
It is strongly recommended that you do so before
proceeding
To log off, enter the Exit command:
SANbox #> exit
To log in to a switch through the serial port, configure the workstation port with the
following settings:
9600 baud
8-bit character
1 stop bit
No parity
Enter an account name and password when prompted.
NOTE:
A switch supports a combined maximum of 19 logins or sessions reserved
as follows:
4 logins or sessions for internal applications such as management
server and SNMP
9 high priority Telnet sessions
6 logins or sessions for Enterprise Fabric Suite 2007 inband and
out-of-band logins, Application Programming Interface (API) inband and
out-of-band logins, and Telnet logins. Additional logins will be refused.
To Next Page
Loading...
