2 – Command Line Interface Usage
Opening and Closing an Admin Session
59183-02 A 2-3
A
2.2
Opening and Closing an Admin Session
The command line interface performs monitoring and configuration tasks.
Commands that perform monitoring tasks are available to all user accounts.
Commands that perform configuration tasks are available only after entering the
Admin Start command to open an Admin session. A user account must have
Admin authority to enter the Admin Start command.
The following is an example of how to open and close an Admin session:
SANbox #> admin start
SANbox (admin) #>
.
.
.
SANbox (admin) #> admin end
To Next Page
Loading...
Need help?
General
