11 – Event Log Configuration
Managing the Event Log Configuration
11-4 59183-02 A
S
11.3.1
Configure the Event Log
You can customize what events are recorded in the switch event log according to
component, severity level, and port. Enter the Set Log Component, Set Log Level,
and Set Log Port commands to filter the events to be recorded. You can choose
from the following component events:
îš„ E_Port events
îš„ Management server events
îš„ Name server events
îš„ Port events
îš„ Switch management events
îš„ Simple Network Management Protocol (SNMP) events
îš„ Zoning events
îš„ Call Home events
The following example configures the event log to record switch management
events with warning and critical severity levels associated with ports 0–3. Entering
the Set Log Save command ensures that this configuration is preserved across
switch resets.
SANbox (admin) #> set log component switch
SANbox (admin) #> set log level warn
SANbox (admin) #> set log port 0 1 2 3
SANbox (admin) #> set log save
11.3.2
Display the Event Log Configuration
Enter the Show Log Settings command to display all event log configuration
settings as shown in the following example:
SANbox #> show log settings
Current settings for log
------------------------
Started True
FilterComponent NameServer MgmtServer Zoning Switch Blade Port Eport Snmp CLI QFS
FilterLevel Info
DisplayLevel Critical
FilterPort 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20
To Next Page
Loading...
Need help?
General
