Qlogic SANbox 5000 Series - 5.3 Viewing and Configuring Ports

9 – Device Security Configuration
Managing Security Sets
9-10 59183-02 A
S
9.5
Managing Security Sets
Managing Security Sets consists of the following tasks:
 Create a Security Set
 Delete a Security Set
 Rename a Security Set
 Copy a Security Set
 Add Groups to a Security Set
 Remove Groups from a Security Set
 Activate a Security Set
 Deactivate a Security Set
All of these tasks except Activate a Security Set and Deactivate a Security Set
require a Security Edit session.
9.5.1
Create a Security Set
Enter the Securityset Create command to create a new security set as shown in
the following example:
SANbox (admin-security) #> securityset create securityset_1
9.5.2
Delete a Security Set
Enter the Securityset Delete command to delete a security set as shown in the
following example:
SANbox (admin-security) #> securityset delete securityset_1
9.5.3
Rename a Security Set
Enter the Securityset Rename command to rename a security set as shown in the
following example:
SANbox (admin-security) #> securityset rename securityset_old securityset_new