5 – Switch Configuration
Setting the Date and Time
59183-02 A 5-19
A
To configure the switch to use an NTP server, enter the Set Setup System
command to enable the NTP client and to specify the NTP server IP address.
SANbox #> admin start
SANbox (admin) #> set setup system
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
EthNetworkDiscovery (1=Static, 2=Bootp, 3=Dhcp, 4=Rarp) [Static ]
EthNetworkAddress (dot-notated IP Address) [10.0.0.1 ]
EthNetworkMask (dot-notated IP Address) [255.255.255.0]
EthGatewayAddress (dot-notated IP Address) [10.0.0.254 ]
AdminTimeout (dec value 0-1440 minutes, 0=never) [30 ]
InactivityTimeout (dec value 0-1440 minutes, 0=never) [0 ]
LocalLogEnabled (True / False) [True ]
RemoteLogEnabled (True / False) [False ]
RemoteLogHostAddress (dot-notated IP Address) [10.0.0.254 ]
NTPClientEnabled (True / False) [False ] True
NTPServerAddress (dot-notated IP Address) [10.0.0.254 ] 10.2.3.4
EmbeddedGUIEnabled (True / False) [True ]
Do you want to save and activate this services setup? (y/n): [n] y
System setup saved and activated.
To Next Page
Loading...
