EasyManuals Logo

Qlogic SANbox 5000 Series Interface Guide

Qlogic SANbox 5000 Series
350 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #121 background imageLoading...
Page #121 background image
59183-02 A 11-1
Section 11
Event Log Configuration
This section describes the following tasks:
îš„ Starting and Stopping Event Logging
îš„ Displaying the Event Log
îš„ Managing the Event Log Configuration
îš„ Clearing the Event Log
îš„ Logging to a Remote Host
îš„ Creating and Downloading a Log File
Event messages originate from the switch or from the management application in
response to events that occur in the fabric. Refer to the SANbox Fibre Channel
Switch Event Message Guide for a complete listing of switch event messages.
Events are classified by the following severity levels:
 Alarm–The alarm level describes events that are disruptive to the
administration or operation of a fabric and require administrator intervention.
Alarms are always logged and always displayed on the screen. Alarm
thresholds can be defined for certain port errors to customize when to
generate an alarm.
 Critical–The critical level describes events that are generally disruptive to
the administration or operation of the fabric, but require no action.
 Warning–The warning level describes events that are generally not
disruptive to the administration or operation of the fabric, but are more
important than the informative level events.
 Informative–The informative level describes routine events associated with a
normal fabric.
11.1
Starting and Stopping Event Logging
Enter the Set Log Stop command to stop recording event messages in the switch
Log as shown in the following example:
SANbox (admin) #> set log stop
Enter the Set Log Start command to start recording event message in the switch
log as shown in the following example:
SANbox (admin) #> set log start

Table of Contents

Other manuals for Qlogic SANbox 5000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Qlogic SANbox 5000 Series and is the answer not in the manual?

Qlogic SANbox 5000 Series Specifications

General IconGeneral
BrandQlogic
ModelSANbox 5000 Series
CategorySwitch
LanguageEnglish

Related product manuals