7 – Zoning Configuration
Managing Zones
59183-02 A 7-17
A
7.7.7
Activate a Zone Set
Enter the Zoneset Activate command to apply zoning to the fabric as shown in the
following example:
SANbox #> admin start
SANbox (admin) #> zoneset activate zoneset_1
7.7.8
Deactivate a Zone Set
Enter the Zoneset Deactivate command to deactivate the active zone set and
disable zoning in the fabric:
SANbox #> admin start
SANbox (admin) #> zoneset deactivate
7.8
Managing Zones
Managing Zones consists of the following tasks:
Create a Zone
Delete a Zone
Rename a Zone
Copy a Zone
Add Members to a Zone
Remove Members from a Zone
All of these tasks require an Admin session and a Zoning Edit session.
7.8.1
Create a Zone
Enter the Zone Create command to create a new zone as shown in the following
example:
SANbox #> admin start
SANbox (admin) #> zoning edit
SANbox (admin-zoning) #> zone create zone_1
SANbox (admin-zoning) #> zoning save
To Next Page
Loading...
