Qlogic SANbox 5000 Series - Copy a Security Set; Add Groups to a Security Set; Remove Groups from a Security Set; Activate a Security Set

9 – Device Security Configuration
Managing Security Sets
59183-02 A 9-11
A
9.5.4
Copy a Security Set
Enter the Securityset Copy command to copy a security set and its contents to a
new security set as shown in the following example:
SANbox (admin-security) #> securityset copy securityset_1 securityset_2
9.5.5
Add Groups to a Security Set
Enter the Securityset Add command to add a group to a security set as shown in
the following example:
SANbox (admin-security) #> securityset add securityset_1 group_isl group_port
9.5.6
Remove Groups from a Security Set
Enter the Securityset Remove command to remove groups from a security set as
shown in the following example:
SANbox (admin-security) #> sescurityset remove securityset_1 group_isl group_port
9.5.7
Activate a Security Set
Enter the Securityset Activate command to apply security to the fabric as shown in
the following example:
SANbox (admin) #> securityset activate securityset_1
9.5.8
Deactivate a Security Set
Enter the Securityset Deactivate command to deactivate the active security set
and disable security in the fabric:
SANbox (admin) #> securityset deactivate