5 – Switch Configuration
Managing Switch Configurations
59183-02 A 5-11
A
5.3
Managing Switch Configurations
The switch configuration determines the basic operational characteristics of the
switch. A switch supports up to 10 configurations including the default
configuration, named Default Config. The current switch operating characteristics
are determined by the active configuration. Only one configuration can be active
at one time.
Each switch configuration contains switch, port, port threshold alarm, and zoning
configuration components. Managing Switch Configurations describes the
following tasks:
îš„ Display a List of Switch Configurations
îš„ Activate a Switch Configuration
îš„ Copy a Switch Configuration
îš„ Delete a Switch Configuration
îš„ Modify a Switch Configuration
îš„ Back Up and Restore a Switch Configuration
5.3.1
Display a List of Switch Configurations
Enter the Config List command to display the configurations stored on the switch
as show in the following example. Notice that the Config List command does not
require an Admin session.
SANbox #> config list
Current list of configurations
------------------------------
default
config_1
config_2
5.3.2
Activate a Switch Configuration
Enter the Config Activate command to activate a switch configuration (config_1)
as shown in the following example:
SANbox (admin) config activate config_1
To Next Page
Loading...
Need help?
General
