14 – Command Reference
Show Interface
14-126 59183-02 A
S
Show Interface
Displays the status of the active network interfaces.
Authority None
Syntax show interface
Examples The following is an example of the Show Interface command:
SANbox #> show interface
eth0 Link encap:Ethernet HWaddr 00:C0:DD:00:BD:ED
inet addr:10.20.68.107 Bcast:10.20.68.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:4712 errors:0 dropped:0 overruns:0 frame:0
TX packets:3000 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:415313 (405.5 Kb) TX bytes:716751 (699.9 Kb)
Interrupt:11 Base address:0xfcc0
RX bytes:20116 (19.6 Kb) TX bytes:20116 (19.6 Kb)
To Next Page
Loading...
