Qlogic SANbox 5000 Series - Rename a Zone Set; Copy a Zone Set; Add Zones to a Zone Set; Remove Zones from a Zone Set

7 – Zoning Configuration
Managing Zone Sets
7-16 59183-02 A
S
7.7.3
Rename a Zone Set
Enter the Zoneset Rename command to rename a zone set as shown in the
following example:
SANbox #> admin start
SANbox (admin) #> zoning edit
SANbox (admin-zoning) #> zoneset rename zoneset_old zoneset_new
SANbox (admin-zoning) #>zoning save
7.7.4
Copy a Zone Set
Enter the Zoneset Copy command to copy a zone set and its contents to a new
zone set as shown in the following example:
SANbox #> admin start
SANbox (admin) #> zoning edit
SANbox (admin-zoning) #> zoneset copy zoneset_1 zoneset_2
SANbox (admin-zoning) #>zoning save
7.7.5
Add Zones to a Zone Set
Enter the Zoneset Add command to add a zone to a zone set as shown in the
following example:
SANbox #> admin start
SANbox (admin) #> zoning edit
SANbox (admin-zoning) #> zoneset add zoneset_1 zone_1 zone_2
SANbox (admin-zoning) #>zoning save
7.7.6
Remove Zones from a Zone Set
Enter the Zoneset Remove command to remove zones from a zone set as shown
in the following example:
SANbox #> admin start
SANbox (admin) #> zoning edit
SANbox (admin-zoning) #> zoneset remove zoneset_1 zone_1 zone_2
SANbox (admin-zoning) #>zoning save