59183-02 A 14-1
Section 14
Command Reference
This section describes the commands of the CLI and the format in which they are
presented. The command format presents the following:
îš„ Access Authority
îš„ Syntax and Keywords
îš„ Notes and Examples
îš„ Command Listing
14.1
Access Authority
The Authority paragraph in each command description indicates what types of
sessions are required to enter that command. Commands associated with
monitoring tasks are available to all account names with no special session
requirement. Commands associated with configuration tasks are available only
within an Admin session. An account must have Admin authority to enter the
Admin Start command, which opens an Admin session.
Some commands require that you open additional editing sessions within an
Admin session such as the following:
îš„ Commands that modify zoning require a Zoning Edit session, which is
opened by the Zoning Edit command. These commands include the Alias,
Zone, Zoneset, and Zoning commands.
îš„ Commands that modify device security require a Security Edit session,
which is opened by the Security Edit command. These command include the
Group, Security, and Securityset commands.
îš„ Commands that modify the switch configuration require a Config Edit
session, which is opened by the Config Edit command. These command
include all of the Set Config commands.
îš„ Commands that modify the Call Home email notification configuration
require a Callhome Edit session, which is opened by the Callhome Edit
command. These commands include the Callhome and Profile commands.
7
To Next Page
Loading...
Need help?
General
