9 – Device Security Configuration
Configuring the Security Database
9-8 59183-02 A
S
To modify the security configuration, you must open an Admin session with the
Admin Start command. An Admin session prevents other accounts from making
changes at the same time either through Telnet or Enterprise Fabric Suite 2007.
You must also open a Config Edit session with the Config Edit command and
indicate which configuration you want to modify. If you do not specify a
configuration name, the active configuration is assumed. The Config Edit session
provides access to the Set Config Security command as shown in the following
example:
SANbox #> admin start
SANbox (admin) #> config edit
SANbox (admin-config) #> set config security
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
FabricBindingEnabled (True / False) [False]
AutoSave (True / False) [True ]
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
SANbox (admin-config)#> config save
SANbox (admin)#> config activate
SANbox (admin)#> admin end
To Next Page
Loading...
Need help?
General
