14 – Command Reference
Config
14-12 59183-02 A
S
Config
Manages the Fibre Channel configurations on a switch. For information about
setting the port and switch configurations, refer to the “Set Config Switch”
command on page 14-80.
Authority Admin session for all keywords except Backup and List
Syntax config
act
ivate [config_name]
backup
cancel
copy [config_source] [config_destination]
del
ete [config_name]
edit [config_name]
list
restore
save [config_name]
Keywords activate [config_name]
Activates the configuration given by [config_name]. If you omit [config_name], the
currently active configuration is used. Only one configuration can be active at a
time.
backup
Creates a file named configdata, which contains the system configuration
information. This keyword does not require an Admin session. Configuration
backup files are deleted from the switch during a power cycle or switch reset.
cancel
Terminates the current configuration edit session without saving changes that
were made.
copy [config_source] [config_destination]
Copies the configuration given by [config_source] to the configuration given by
[config_destination]. The switch supports up to 10 configurations including the
default configuration.
del
ete [config_name]
Deletes the configuration given by [config_name] from the switch. You cannot
delete the default configuration (Default Config) nor the active configuration.
To Next Page
Loading...
Need help?
General
