14 – Command Reference
Reset
14-54 59183-02 A
S
switch
Resets the switch without a power-on self test. This is the default. This reset
disrupts traffic and does the following:
Activates the pending firmware.
Closes all management sessions.
Clears the event log. To save the event log before resetting, refer to the
“Set Log” command on page 14-86.
To reset the switch with a power-on self test, refer to the “Hardreset” command on
page 14-35. To reset the switch without disrupting traffic, refer to the “Hotreset”
command on page 14-38.
system
Resets the system configuration settings to the factory default values as
described in Table 14-14.
zoning
Clears the zoning database and deactivates the active zone set. The zoning
configuration parameters (MergeAutoSave, DefaultZone, DiscardInactive) remain
unchanged. Refer to Table 14-10 for information about the zoning configuration
parameters.
NOTE:
The following files are deleted from the switch during a switch reset:
Firmware image files that have not been unpacked
Configuration backup files
Support files
NOTE:
Because this keyword changes network parameters, the
workstation could lose communication with the switch.
This keyword does not affect installed license keys.
To Next Page
Loading...
Need help?
General
