14 – Command Reference
Set Setup System
59183-02 A 14-107
A
Examples The following is an example of the Set Setup System command:
SANbox (admin) #> set setup system
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
EthNetworkDiscovery (1=Static, 2=Bootp, 3=Dhcp, 4=Rarp) [Static ]
EthNetworkAddress (dot-notated IP Address) [10.0.0.1 ]
EthNetworkMask (dot-notated IP Address) [255.255.255.0]
EthGatewayAddress (dot-notated IP Address) [10.0.0.254 ]
AdminTimeout (dec value 0-1440 minutes, 0=never) [30 ]
InactivityTimeout (dec value 0-1440 minutes, 0=never) [0 ]
LocalLogEnabled (True / False) [True ]
RemoteLogEnabled (True / False) [False ]
RemoteLogHostAddress (dot-notated IP Address) [10.0.0.254 ]
NTPClientEnabled (True / False) [False ]
NTPServerAddress (dot-notated IP Address) [10.0.0.254 ]
EmbeddedGUIEnabled (True / False) [True ]
NTPClientEnabled Enables (True) or disables (False) the Network Time Pro-
tocol (NTP) client on the switch. This client enables the
switch to synchronize its time with an NTP server. This
feature supports NTP version 4 and is compatible with
version 3. An Ethernet connection to the server is
required and you must first set an initial time and date on
the switch. The synchronized time becomes effective
immediately. The default is False.
NTPServerAddress The IP address of the NTP server from which the NTP cli-
ent acquires the time and date. The default is 10.0.0.254.
EmbeddedGUIEnabled Enables (True) or disables (False) the QuickTools man-
agement application. Changing this parameter to False
while QuickTools is running will terminate the application.
The default is True.
Table 14-26. System Configuration Settings (Continued)
Entry Description
To Next Page
Loading...
Need help?
General
