14 – Command Reference
Uptime
59183-02 A 14-169
A
Uptime
Displays the elapsed up time since the switch was last reset and reset method. A
hot reset or non-disruptive firmware activation does not reset the elapsed up time
reported by this command.
Authority None
Syntax uptime
Examples The following is an example of the Uptime command:
SANbox #> uptime
Elapsed up time : 0 day(s), 2 hour(s), 28 min(s), 44 sec(s)
Reason last reset: NormalReset
To Next Page
Loading...
