1. Open the feeder and push the left of the upper blue release lever to raise the upper
drive assembly.
2. Pull up the brush release lever.
3. Raise the brush and lift the complete brush holder assembly.
4. Lift the metal retainer to remove the sponge.
Remember its direction.
5. Clean the sponge and the brush.
6. Re-install the sponge and retainer.
7. Put the brush back and push the release lever back down until it snaps into place.
12
Maintaining your Mailing System
289
| Page 289 | Jun-21-2021 12:11 |
To Next Page
Loading...
