Using the Feeder
The procedure below describes how to place a stack of mail pieces in the Hopper.
Depending on the weighing method you choose to run mail, you may have to insert
the envelopes one by one or place a stack of envelopes in the hopper.
How to Use the Feeder
Feeding a stack of mail pieces:
1. Fan the envelopes to separate them.
2. Bevel the edge of the stack.
3. Place the envelopes in the hopper, their upper edge resting against the rear guide.
4. Adjust the side guide for large envelopes. To adjust the guide, push it gently to
rest against the envelopes, without pressing.
Envelopes flaps must be closed, not nested.
Do not try to seal self-adhesive envelopes.
3
Processing Mail
39
| Page 39 | Jun-21-2021 12:11 |
To Next Page
Loading...
