How to Adjust the Sealing Water Flow
Before you adjust the sealing water flow, make sure that the brushes and sponge are
clean.
To adjust the sealing water flow:
1. Set the water flow using the back lever.
When standing in front of the feeder:
- Push the lever towards the left-hand side to increase the water level.
- Push the lever towards the right-hand side to decrease the water level.
How to Clean the Feeder Belts and Rollers
To clean the feeder belts and rollers:
12
Maintaining your Mailing System
291
| Page 291 | Jun-21-2021 12:11 |
To Next Page
Loading...
