QUANTA STRATOS S210 Series S210-X12RS - Removing the HDD Backplane (3.5 HDD SKU)

INSTALLING HARDWARE REMOVING THE HDD BACKPLANE (3.5” HDD SKU)
2-62
Removing the HDD Backplane (3.5”
HDD SKU)
Prerequisite:
Prerequisite:
Remove the HDDs. See Removing a 3.5” Hard Drive on
page 2-6.
Remove the top cover. See Opening the Top Cover on
page 2-2
1. Disconnect the following cables from the HDD BP:
a. Device 0 Connector connect to HDD 0
b. Device 1 Connector connect to HDD 1
c. Device 2 Connector connect to HDD 2
d. Device 3 Connector connect to HDD 3
e. 10 pin Power connector for BP with +12V, +5V, +3.3V
f. IPMB connector lining to on board BMC to control FAN
Speed
g. SGPIO connector for HDD LED Decode.
h. System FAN 0 for CPU 0 Block
i. System FAN 1 for CPU 0 Block
j. System FAN 2 for CPU 0 Block
k. System FAN 3 for CPU 1 Block
l. System FAN 4 for CPU 1 Block
m. System FAN 5 for CPU 1 Block
Figure 2-93. HDD BP Connectors
a
b
c
e
f
d
g
h
j
kl
i
m