QUANTA STRATOS S210 Series S210-X12RS - Removing an Ibbu

INSTALLING HARDWARE REMOVING AN IBBU
2-42
5. Secure the iBBU bracket to the chassis with screw(s).
Figure 2-62. Installing iBBU Holder to Module
6. Connect the iBBU cable to the battery.
7. Connect the iBBU cable to the expansion card.
Removing an iBBU
Prerequisite:
Prerequisite:
Remove the top cover. See Opening the Top Cover on
page 2-2.
1. Disconnect the iBBU cable from the card.
2. Disconnect the iBBU cable from the battery.
3. Remove screw(s) securing the iBBU bracket.
Figure 2-63. Removing iBBU Bracket Screws
4. Remove the iBBU bracket.
Note:
The iBBU can be connected to either a mezzanine card or an
expansion card.
1
2
1
3
4
3