QUANTA STRATOS S210 Series S210-X12RS - Installing Fan Module Assembly

INSTALLING HARDWARE INSTALLING FAN MODULE ASSEMBLY
2-46
Installing Fan Module Assembly
Prerequisite:
Prerequisite:
Remove the top cover. See Opening the Top Cover on
page 2-2
1. Align the fan module assembly with the screw holes on
the chassis.
Figure 2-69. Installing Fan Module Assembly Screws
2. Secure the fan module assembly to the chassis with four
(4) screws.
3. Repeat steps 1 and 2 to install the additional fan module
assembly.
4. Connect six (6) fan module cables to the connectors on
the HDD backplane.
Figure 2-70. Connecting the Fan Assembly Cables