QUANTA STRATOS S210 Series S210-X12RS - Installing a Heat Sink

INSTALLING HARDWARE INSTALLING A HEAT SINK
2-15
Installing a Heat Sink
Prerequisite:
Prerequisite:
Remove the top cover. See Opening the Top Cover on
page 2-2
1. Align the heat sink. Make sure the airflow sticker points to
the rear of the chassis.
2. Place the heat sink on the processor.
3. In a sequential order, secure the heat sink with four
screws.
Figure 2-21. Installing the Heat Sink
Important:
Tighten the captive screws in the sequence indicated in the
illustration.