QUANTA STRATOS S210 Series S210-X12RS - Mezzanine Card; Installing a LAN Mezzanine Card

INSTALLING HARDWARE MEZZANINE CARD
2-29
2.11 Mezzanine Card
Installing a LAN Mezzanine Card
Prerequisite:
Prerequisite:
Remove the PCIe riser assembly. See Removing the
PCIe Riser Assembly on page 2-25.
1. Align the module with the screw holes on the module sup-
port plate.
Figure 2-39. ModuleAssembly Screws
2. Secure four (4) screws to the module support plate.
3. Insert the linking board into the module connector.
Figure 2-40. Linking Board and Module Connector