QUANTA STRATOS S210 Series S210-X12RS - Power Supply Unit; Removing a Power Supply Unit

INSTALLING HARDWARE POWER SUPPLY UNIT
2-9
2.4 Power Supply Unit
The system supports both single and redundant power supplies
as shown in the following illustrations.
Removing a Power Supply Unit
1. Pull the PSU handle up to the open position.
Figure 2-13. Opening the PSU Handle
2. Press and hold the locking latch lever.
Figure 2-14. Removing the PSU
3. Pull the PSU from the system.
CAUTION!
DISCONNECT THE POWER SUPPLY UNIT FROM THE POWER
SOURCE BEFORE REMOVING PSU. FAILURE TO DO SO COULD
RESULT IN DAMAGE TO THE EQUIPMENT OR PERSONAL INJURY.
Note:
The redundant power supply unit can be replaced without
shutting down the system.
!

