RAIL KIT ASSEMBLY INSTALLING THE RACK BRACKETS
6-2
Installing the Inner Rail
Follow these instructions to install inner rail:
1. Slide the release tab to the open position and remove the
inner rail from the rail kit assembly.
Figure 6-1. Extending the Rail
2. Align and insert the holes on the inner rail into the pins on
the side of the chassis.
3. Slide the inner rail until the latch key on the rail locks and
is secure to the chassis.
4. Install and secure the screw to the inner rail.
Figure 6-2. Securing the Rail to the Server (2.5” HDD SKU
shown)
5. Repeat steps 1 through 4 for the remaining side.
To Next Page
Loading...
