QUANTA STRATOS S210 Series S210-X12RS - Installing the Expander Backplane

INSTALLING HARDWARE INSTALLING THE EXPANDER BACKPLANE
2-49
3. Slide the expander BP toward the rear of the chassis until
the B2B Connectors (a, b & c) are free from the HDD BP.
Figure 2-73. Removing the Expander Backplane
4. Continue to slide the expander BP toward the rear of the
chassis until the BP is free of the chassis pins.
5. Remove the HDD expander BP from the chassis.
Installing the Expander Backplane
Prerequisite:
Prerequisite:
Remove the top cover. See Opening the Top Cover on
page 2-2
1. Align the holes in the expander backplane (BP) with the
chassis pins.
Figure 2-74. Installing the Expander Backplane
2. Insert the chassis pins in the expander BP holes.
HDD Backplane
a
b
c
Guide Pins
HDD Backplane
a
b
c
Guide Pins