QUANTA STRATOS S210 Series S210-X12RS - Installing the HDD Backplane (3.5 HDD SKU)

INSTALLING HARDWARE INSTALLING THE HDD BACKPLANE (3.5” HDD SKU)
2-64
Installing the HDD Backplane (3.5”
HDD SKU)
Prerequisite:
Prerequisite:
Remove the HDDs. See Removing a 3.5” Hard Drive on
page 2-6.
Remove the top cover. See Opening the Top Cover on
page 2-2.
1. Align the HDD backplane with the screw holes in the
chassis.
Figure 2-96. Aligning the 3.5” HDD Backplane
2. Secure the HDD Backplane to the chassis with five (5)
screws.
Figure 2-97. Installing the 3.5” HDD Backplane Screws
3. Connect the following cables to the HDD BP:
a. Device 0 Connector connect to HDD 0
b. Device 1 Connector connect to HDD 1
c. Device 2 Connector connect to HDD 2
d. Device 3 Connector connect to HDD 3
e. 10 pin Power connector for BP with +12V, +5V, +3.3V