QUANTA STRATOS S210 Series S210-X12RS - Installing a Mainboard Module

INSTALLING HARDWARE INSTALLING A MAINBOARD MODULE
2-12
3. Lift mainboard in an angle to release the connectors from
the slots on rear panel.
Figure 2-18. Removing the Mainboard
4. Remove the mainboard from the chassis.
.
Installing a Mainboard Module
Prerequisite:
Prerequisite:
Remove the top cover. See Opening the Top Cover on
page 2-2.
1. Place the mainboard on the chassis.
2. Align the mainboard with the port openings on the rear of
the chassis.
3. Align the mainboard opening with the chassis guide pin.
4. Install the mainboard on the chassis.
Port Openings