QUANTA STRATOS S210 Series S210-X12RS - Page 196

CHAPTER TITLE WEB GRAPHICAL USER INTERFACE (GUI) FOR ESMS
4-23
This Active Directory Settings page in MegaRAC SP-X as
shown on the following figure, allows to Configure Active Direc-
tory Server Settings.
To open Active Directory Settings page, click Configuration >
Active Directory from the main menu. A sample screenshot of
Active Directory Settings Page is shown in the following screen-
shot:
Figure 4-15. Active Directory Settings Page
Procedure:
Entering the details in Advanced Active Directory Settings Page
Table 4-19: Active Directory Settings Page
I
TEM DESCRIPTION
Advanced Settings
Active Directory advanced settings configuration
options are as follows:
 Enable Active Directory Authentication,
 User Domain name,
 Time Out, and
 Up to three Domain Controller Server
Addresses.
Role Group ID
The name that identifies the role group in the
Active Directory.
 Role Group Name is a string of 255 alpha-
numeric characters.
 Special symbols hyphen and underscore are
allowed.
Group Name
This name identifies the role group in Active
Directory.
 Role Group Name is a string of 255 alpha-
numeric characters.
 Special symbols hyphen and underscore are
allowed.
Group Domain
The domain where the role group is located.
Note:
 Domain Name is a string of 255 alpha-
numeric characters.
 Special symbols hyphen, underscore and dot
are allowed.
Group Privilege The level of privilege to assign to this role group.
Add Role Group To add a new role group to the device.
Modify role Group
To modify that role group. Alternatively, double
click on the configured slot.
Delete Role Group To delete an existing Role Group.
Table 4-19: Active Directory Settings Page (Continued)
I
TEM DESCRIPTION