QUANTA STRATOS S210 Series S210-X12RS - Page 205

CHAPTER TITLE WEB GRAPHICAL USER INTERFACE (GUI) FOR ESMS
4-32
Table 4-23: Network Settings Page
I
TEM DESCRIPTION
LAN Interface Lists the LAN interfaces.
LAN Settings To enable or disable the LAN Settings.
MAC Address
This field displays the MAC Address of the
device. This is a read only field.
IPv4 Settings
This option lists the IPv4 configuration settings.
 Obtain IP Address automatically: This option
is to dynamically configure IPv4 address
using DHCP (Dynamic Host Configuration
Protocol).
 IPv4 Address, Subnet Mask, and Default
Gateway: These fields are for specifying the
static IPv4 address, Subnet Mask and
Default Gateway to be configured to the
device.
Note:
 IP Address made of 4 numbers separated by
dots as in "xxx.xxx.xxx.xxx".
 Each Number ranges from 0 to 255.
 First Number must not be 0.
IPv6 Configuration
This option lists the following IPv6 configuration
settings.
 IPv6 Settings: This option is to enable the
IPv6 settings in the device.
 Obtain an IPv6 address automatically: This
option is to dynamically configure IPv6
address using DHCP (Dynamic Host
Configuration Protocol).
 IPv6 Address: To specify a static IPv6
address to be configured to the device. Eg:
2004:2010
 Subnet Prefix length: To specify the subnet
prefix length for the IPv6 settings.
Note:
Value ranges from 0 to 128.
 Default Gateway: Specify v6 default gateway
for the IPv6 settings.
VLAN Configuration
It lists the VLAN configuration settings.
 VLAN Settings: To enable/disable the VLAN
support for selected interface.
 VLAN ID: The Identification for VLAN config-
uration.
 Value ranges from 1 to 4095.
 VLAN Priority: The priority for VLAN configu-
ration.
 Value ranges from 1 to 7.
 7 is the highest priority for VLAN.
Save To save the entries.
Table 4-23: Network Settings Page (Continued)
I
TEM DESCRIPTION